Honda Accord: Gauges
- Component Location Index
- Self-diagnostic Function
- Circuit Diagram
- DTC Troubleshooting
- Gauge Control Module Input Test
- Rewriting the ODO Data and Transferring the Maintenance Minder Data to a New Gauge Control Module
- Gauge Control Module Replacement
- Outside Air Temperature indicator Calibration
- Outside Air Temperature Sensor Test
- Outside Air Temperature Sensor Replacement
Washer Tube Replacemen
1. Remove the right front inner fender (see page 20-290).
2. Remove the windshield washer nozzles and clips, then remove the tubes.
*1:USA models
*2: Canada models
3. Install in the reverse or ...
See also:
Lower Arm A Replacement
1. Raise and support the vehicle (see page 1-13).
2. Remove the rear wheel.
3. Remove the parking brake cable mounting bolt (B).
4. Remove the lower arm A mounting bolts, then
remove lower a ...
DTC Troubleshooting
DTC P0420: Catalyst System Efficiency Below
Threshold
NOTE:
- Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information (see pa ...
General Troubleshooting Information
Intermittent Failures
The term Intermittent failure means a system may have
had a failure, but it checks OK now. If the malfunction
indicator lamp (MIL) on the dash does not come on,
check for poo ...