Honda Accord: Fuel Supply System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Fuel and Emissions / Fuel Supply System
- Component Location Index
- DTC Troubleshooting
- Fuel Pump Circuit Troubleshooting
- Fuel Pressure Relieving
- Fuel Pressure Test
- Fuel Tank Draining
- Fuel Line Inspection
- Fuel Line/Quick-Connect Fitting Precautions
- Fuel Line/Quick-Connect Fitting Removal
- Fuel Line/Quick-Connect Fitting Installation
- Fuel Tank Unit Removal and Installation
- Fuel Pulsation Damper Replacement
- Fuel Pressure Regulator Replacement
- Fuel Filter Replacement
- Fuel Pump/Fuel Gauge Sending Unit Replacement
- Fuel Tank Replacement
- Fuel Fill Pipe Removal/Installation
- Fuel Gauge Sending Unit Test
- Low Fuel Indicator Test
ECM/PCM Idle Learn Procedure
The idle learn procedure must be done so the ECM/PCM
can learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of
these actions:
- Replace ECM/PCM.
...
See also:
DTC Troubleshooting
DTC P062F: Powertrain Control Module (PCM)
Internal Control Module Keep Alive Memory
(KAM) Error
NOTE: Before you troubleshoot record all freeze data
and any on-board snapshot with the HDS, and re ...
Mode Control Motor Test
'08-09 models with A/T and '10 model
with A/T
NOTE; Before testing the motor, check for HVAC DTCs
(see page 21-9).
1. Disconnect the 7P connector from the mode control
motor.
Incorrectly app ...
Mainshaft Bearing and Oil Seal Replacement
Special Tools Required
- Oil Seal Driver, 65 07JAD-PL90100
- Adjustable Bearing Puller, 20-”40 mm 07736-A01000B
- Bearing Driver Attachment, 42 x 47 07746-0010300
- Driver Handle, 15 x 135L ...
