Honda Accord: Fuel Pressure Regulator Replacement
1. Remove the fuel tank unit (see page 11-320).
2. Remove the reservoir (A).
3. Remove the bracket (B).
4. Remove the fuel pressure regulator (C).
5. Install the parts in the reverse order of removal with new O-rings (D) and a new bracket. When installing the fuel tank unit, align the marks on the unit and the fuel tank (see page 11-321).
NOTE: - Coat the O-rings with clean engine oil; do not use any other oils or fluids, - Do not pinch the O-rings during installation.
-СћUse all the new parts supplied in the pressure regulator replacement kit.
Fuel Pulsation Damper Replacement
PZEV model
1. Relieve the fuel pressure (see page 11-306).
2. Remove the engine cover.
3. Place a wrench (A) on the fuel rail (B).
4. Place a wrench (C) on the fuel pulsation damper (D),
an ...
Fuel Filter Replacement
The fuel filter should be replaced whenever the fuel
pressure drops below the specified value (see page
11-308), after making sure that the fuel pump and the
fuel pressure regulator are OK.
1. R ...
See also:
DTC Troubleshooting
DTC B112S; Driver's Power Window Motor A
Pulse Malfunction
DTC B1126: Driver's Power Window Motor B
Pulse Malfunction
NOTE: If you are troubleshooting multiple DTCs, be sure
to follow the instruc ...
MAF Sensor/IAT Sensor Replacement
1. Disconnect the MAF sensor/IAT sensor connector (A).
2. Remove the screws (B).
3. Remove the MAF sensor/IAT sensor (C).
4. Install the parts in the reverse order of removal with a
new O-ri ...
Front Fender Trim Replacement
2-door
NOTE:
- Take care not to scratch the front grille cover or the
body.
- When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
- The left side is show ...