Honda Accord: Fuel Pipe Protector Replacement
NOTE: - Put on gloves to protect your hands.
- Take care not to scratch the body.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove the left rear wheel (see page 18-39).
2. Detach the clips, then remove the fuel pipe protector (A).
3. Install the protector in the reverse order of removal, and note these items: - If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
Middle Floor Undercover Replacement
Left Side NOTE: - Put on gloves to protect your hands. - Take care not to scratch the body. 1. Remove the bolts and release the hook (A), then remove the left middle floor undercover (B). ...Rear Inner Fender Replacement
NOTE: Take care not to scratch the rear bumper or the body. 1. Remove the screws, then remove the rear inner fender (A) from the rear bumper (B) and the body. 2. Install the inner fender in th ...See also:
Playing Discs (Models with navigation system)
Playing Discs (Models with navigation system)
Your vehicle’s audio system has an
in-dash disc changer with the same
controls used for the radio. To
operate the disc changer, the ignition
...
Valve Body Valve Installation
1. Coat all parts with ATF before assembly.
2. Install the valves and the springs in the sequence
shown for the main valve body (see page 14-277), the
regulator valve body (see page 14-279), and ...
Rear Safing Sensor Replacement
Removal
1. Do the battery t e r m i n a l disconnection p r o c e d u r e (see
page 22-91), t h e n wait at least 3 minutes before
starting w o r k .
2. Remove t h e rear seat c u s h i o n (see ...