Honda Accord: Fuel Filter Replacement
The fuel filter should be replaced whenever the fuel pressure drops below the specified value (see page 11-308), after making sure that the fuel pump and the fuel pressure regulator are OK.
1. Remove the fuel tank unit (see page 11-320).
2. Remove the fuel filter set (A).
3. Check these items before installing the fuel tank unit - When connecting the wire harness (B), make sure the connection is secure and the connectors are firmly locked into place.
- When installing the fuel gauge sending unit (C), make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.
4. Install the parts in the reverse order of removal with new O-rings (D) and a new bracket (E). When installing the fuel tank unit, align the marks on the unit and the fuel tank (see page 11-321).
NOTE: - Coat the O-rings with clean engine oil; do not use any other oil or fluid.
- Do not pinch the O-rings during installation.
- Use all the new parts supplied in the fuel filter replacement kit.
Fuel Pressure Regulator Replacement
1. Remove the fuel tank unit (see page 11-320).
2. Remove the reservoir (A).
3. Remove the bracket (B).
4. Remove the fuel pressure regulator (C).
5. Install the parts in the reverse order ...
Fuel Pump/Fuel Gauge Sending Unit
Replacement
1. Remove the fuel tank unit (see page 11 -320).
2. Remove the fuel level sensor (fuel gauge sending
unit) (A) from the fuel tank unit (B).
3. Check these items before installing the fuel tank ...
See also:
Trunk Lid Adjustment
1. Remove the rear shelf (see page 20-128).
2. Pry up the notches (A) to release the rear hooks (B), and pull up the cap (C)
to release the side hooks (D), then remove
the cap.
3. Slightly lo ...
Engine Assembly
...
Function Test
NOTE: The right power mirror is controlled by the front
passenger's power w i n d o w s w i t c h . W h e n t h e power
mirror s w i t c h is o p e r a t e d , t h e d o o r m u l t i p l e x c o n ...