Honda Accord: Fuel Fill Door Adjustment - Fuel Fill Door - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Fuel Fill Door Adjustment

1. Slightly loosen the hinge mounting bolts (A).

2 . Adjust the fuel fill door (B) in or out until it is flush with


2 . Adjust the fuel fill door (B) in or out until it is flush with the body, and up or down as necessary to equalize the gaps.

3. Tighten the hinge mounting bolts.

4. Check that the fuel fill door opens properly and locks securely, and check that the rear of the door is flush with the body.

5. Apply multipurpose grease to each location indicated by the arrows.

6. Apply touch-up paint to the hinge mounting bolts and


6. Apply touch-up paint to the hinge mounting bolts and around the hinges.

    Fuel Fill Door
    ...

    Fuel Cap Adapter Replacement
    NOTE: - Put on gloves to protect your hands. - Take care not to scratch the body. 1. Remove the fuel pipe protector (see page 20-294). 2. Remove the fuel cap (A) by turning it counterclockw ...

    See also:

    Front Accessory Power Socket Test/Replacement
    NOTE: If all of the front and console accessory power sockets do not work, check the No. 18 (7.5: A> fuse in the driver's under-dash fuse/relay box and ground (G503) first. 1. Remove the cent ...

    Air Cleaner Removal/Installation
    1. Disconnect the MAF sensor/IAT sensor connector (A). 2. Remove the harness clamps (B) and the bolts (C). 3. Loosen the band (D), then remove the air cleaner housing (E). 4. Install the par ...

    Transmission Installation
    Special Tools Required - Engine Support Hanger, A and Reds AAR-T1256* - Engine Hanger Adapter VSB02C000015* - Subframe Adapter VSB02C000016* - Subframe Alignment Pin 070AG-SJAA10S *: Are availabl ...