Honda Accord: Front Turn Signal/Side Marker Light Bulbs - Replacing Light Bulbs - Maintenance - Honda Accord 2013-2026 Owner's ManualHonda Accord: Front Turn Signal/Side Marker Light Bulbs

When replacing, use the following bulbs.

1. Turn the steering wheel all the way to the

1. Turn the steering wheel all the way to the opposite side from the light being replaced.

Passenger side: Turn the steering wheel to the left.
Driver side: Turn the steering wheel to the right.
2. Remove the holding clips and screw, and pull the inner fender back.

3. Turn the socket to the left and remove it.

3. Turn the socket to the left and remove it.
4. Push in the old bulb, rotate to the left until it unlocks, and remove.
5. Insert a new bulb.

Insert a flat-tip screwdriver, lift and remove the central pin to remove the clip.

Insert the clip with the central pin raised, and push

Insert the clip with the central pin raised, and push until it is flat.

Side Turn Signal/Emergency Indicator Light Bulbs*

    Fog Light Bulbs*
    When replacing, use the following bulbs. 1. Loosen the screw using a Phillips-head screwdriver.  - Be careful not to rotate the screwdriver more than one or two times to the left. ...

    Side Turn Signal/Emergency Indicator Light Bulbs*
    Door mirrors have the side turn lights. Have an authorized Honda dealer inspect and replace the light bulbs. ...

    See also:

    Front Passenger's Power Window Switch Input Test
    1. Turn the ignition switch to LOCK (0), open and close the driver's door, then remove the front passenger's power window switch. • 4-door (see page 22-306) • 2-door (see page 22-307) ...

    How to Refuel
    1. Stop your vehicle with the service station pump on the left side of the vehicle in the rear. 2. Turn off the engine. 3. Push on the fuel fill door release handle at the foot of the driv ...

    Upper Arm Replacement
    Special Tools Required -Ball Joint Thread Protector, 10 mm 07AAF-SECA120 - Ball Joint Remover, 28 mm 07MAC-SL0A202 1. Raise and support the vehicle (see page 1-13). 2. Remove the front wheel. ...