Ball Joint Boot Inspection / Replacemen

Special Tools Required - Clip Guide, 45 mm 070AG-SJA0300 -Clip Guide, 41 mm 07974-SA50700 1. Check the ball joint boot for weakness, damage, cracks, and grease leaks. NOTE: - If the ball joint ...

Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required - Ball Joint Thread Protector, 14 mm 07AAE-SJAA100 - Ball Joint Thread Protector, 12 m m 07AAF-SDAA100 - Ball Joint Thread Protector, 10 m m 07AAF-SECA120 ...

See also:

Glove Box Striker Replacement
SRS components are located in this area. Review the SRS component locations, 2-door {see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repair ...

Damper/Spring Removal and Installation
Removal 1. Raise and support the vehicle (see page 1-13). 2. Remove the rear wheel. 3. Fold down the rear seat-back, then remove the lid (A). NOTE: For 4-door, lift up the tab (B) inside und ...

EVAP Canister Replacement
1. Raise the vehicle on a lift. 2. Remove the wheel sensor harness clamps (A) 3. Support the rear subframe with a transmission jack and a wooden block as shown. 4. Remove the rear subframe m ...