Honda Accord: Front Seat Torsion Bar Replacement
2-door Driver's seat (manual height adjustable seat)
NOTE: - Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove the front seat (see page 20-194).
2. Adjust the seat to its maximum height.
3. Release the hook strips from both sides and under of the seat cushion frame, then loosen the seat cushion cover (see step 24 on page 20-232).
4. Lever a hooked shaped end of the torsion bar (A) down using a large flat-tip screwdriver.
5. While holding the torsion bar (A) twisted, pull out the end of the torsion bar of the seat frame, then carefully loosen the torsion bar.
6. Remove the other side end of the torsion bar from the hook (B), then remove the torsion bar from the seat frame.
7. Install the torsion bar in the reverse order of removal.
Front Seat Slide Lever Replacement
Driver's seat (manual height adjustable
seat)/passenger's seat
NOTE:
- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
1. Remove the front seat {see pa ...
Rear Seat Access Cable Replacement
2-door Passenger's Seat
NOTE:
- Put on gloves to protect your hands.
- Take care not to kink the rear seat access cable.
- The right rear seat access cable is shown; the left rear
seat access ...
See also:
For Safe Driving
The following pages explain your vehicle's safety features and how to use
them
properly. The safety precautions below are ones that we consider to be among the
most important. ...
Voice Control Switch
Replacement
1. Remove the steering wheel (see page 17-6).
2. Remove the voice control switch (see page 17-7).
3. Install the voice control switch in the reverse order of
removal. ...
Important Safety Precautions
You’ll find many safety
recommendations throughout this
section, and throughout this manual.
The recommendations on this page
are the ones we consider to be the
most important.
Always Wear ...