Honda Accord: Front Seat Slide Lever Replacement - Seats - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Front Seat Slide Lever Replacement

Driver's seat (manual height adjustable seat)/passenger's seat

NOTE: - Put on gloves to protect your hands.

- Take care not to tear or damage the seat covers.

1. Remove the front seat {see page 20-194).

2. Lift up the front seat, and pull out the slide lever (A) while prying up the spring (B) f r om the lever holders (C) of both seat tracks, then remove the lever.

3. Install the slide lever by pushing on it into the lever


3. Install the slide lever by pushing on it into the lever holders of both seat tracks until the springs snap the slits in the lever.

4. Apply multipurpose grease to the pivot areas of the slide locks.

    Front Seat Slide Motor Replacement
    SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repair ...

    Front Seat Torsion Bar Replacement
    2-door Driver's seat (manual height adjustable seat) NOTE: - Put on gloves to protect your hands. - Take care not to tear or damage the seat covers. - When prying with a flat-tip screwdriver, ...

    See also:

    Mirror Holder Replacement
    NOTE: - Put on gloves to protect your hands. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. 1. Carefully push on the top edge of the mirror holder ( ...

    Transmission Range Switch Test
    1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the . vehicle. Make sure it is securely supported. 2. Remove the left front wheel. 3. ...

    Sun Visor
    To use the sun visor, pull it down. When using the sun visor for the side window, remove the support rod from the clip, and swing it out. In this position, the sun visor can be adjusted by m ...