Honda Accord: Front Passenger's Power Window
Switch Input Test
1. Turn the ignition switch to LOCK (0), open and close the driver's door, then remove the front passenger's power window switch.
• 4-door (see page 22-306)
• 2-door (see page 22-307)
2. Disconnect the 37P connector (A) from the front passenger's power window switch (B).
*: With front passenger's power window AUTO UP/AUTO DOWN function
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
• If the terminals look OK, go to step 4 .
4. Reconnect the connector to the front passenger's power window switch, turn the ignition switch to ON (II), and do these input tests at the following connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, go to step 5.
*: Front passenger's power window AUTO UP/AUTO DOWN function
5. Turn the ignition switch to LOCK (0), open and close the driver's door, then disconnect the 37P connector from the front passenger's power window switch again.
6, With the connector still disconnected, do these input tests at the following connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, replace the front passenger's power window switch, then go to step 7.
- 4-door (see page 22-306)
- 2-door (see page 22-307)
7. With the front passenger's power window AUTO UP/AUTO DOWN function, reset the power window control unit (see page 22-280).
Power Window Master Switch Input
Test
NOTE: Before testing, troubleshoot the multiplex integrated control unit
first, using B-CAN System Diagnosis Test Mode
A (see page 22-134).
1. Turn the ignition switch to LOCK (0), open and clos ...
Driver's Power Window Motor Test
Motor Test
1. Remove the power window master switch.
• 4-door (see page 22-305)
• 2-door (see page 22-306)
2. Test the motor in each direction by connecting battery
power and ground t ...
See also:
Shift Lock Release
This allows you to move the shift
lever out of Park if the normal
method of pushing on the brake
pedal and pressing the release
button does not work.
1. Set the parking brake.
2. Remove the ...
Glove Box Light Replacement
"08-09 models
1. Remove the glove box stops and damper (see page
20-174).
2. Turn the bulb socket (A) 45 В° counterclockwise to
remove it.
Glove Box Light: 2 CP
3. Remove the bulb (B) ...
Warm Up TWC Removal/Installation
1. Raise the vehicle on a lift.
2. Remove the secondary H02S (Sensor 2) (see page
11-197).
3. Remove the bolts (A).
4. Remove the WU-TWC bracket (B).
5. Lower the vehicle.
6. Remove th ...