Honda Accord: Front HFL-ANC Microphone
Removal/Installation
NOTE: • Put on gloves to protect your hands.
• Take care not to scratch the dashboard and related parts.
• Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
1. Remove the roof console (see page 20-140), and disconnect the connector (A) from the front HFL-ANC microphone (B).
2. Remove the screws and the front HFL-ANC microphone.
3. Install the microphone in the reverse order of removal.
HFL Switch Test
1. Remove the driver's airbag (see page 24-211)
2. Remove the steering wheel (see page 17-6).
3. Measure the resistance between terminals No. 3 and
No. 4 in each switch position according to the ...
HFL Switch Removal/Installation
1. Remove the steering wheel (see page 17-6).
2. Remove the HFL switch (see page 17-7).
3. Install the HFL switch in the reverse order of removal. ...
See also:
Outside Air Temperature indicator
Calibration
NOTE: To test the outside air temperature sensor (see
page 21-185).
Description
The outside air temperature sensor is located behind the
center of the front bumper. The gauge control module
uses ...
XM® Radio Service*
• Subscribing to XM® Radio
1. You need your radio ID ready before registering for subscription. To see
the ID in
the display: Turn the selector knob or the interface dial until 0 appears.
2. ...
Valve Clearance Adjustment
Special Tools Required
. Locknut Wrench 07MAA-PR70120
. Adjuster 07MAA-PR70110
NOTE: Connect the Honda Diagnostic System (HDS) to
the data link connector (DLC) and monitor the engine
coolant temp ...