Honda Accord: Front Door Sash Inner Trim Replacement
2-door
NOTE: Take care not to scratch the door.
1. Remove the door panel (see page 20-12).
2. Lower the glass fully.
3. Remove the door sash inner trim (A).
-1. Detach the clip fastening the trim.
-2. Pull back along the outside edge of the trim to release the hook strip (B) from the door glass opening flange at the A-pillar area and the roof area of the door sash.
-3. Release the hook (C) from the glass run channel (D) at the rear corner area of the door sash.
-4. Pull back along the outside edge of the trim to release the hook strip (E) from the door glass , opening flange at the B-pillar area of the door sash.
-5. Release the rear hook (F) from the door.
4. Install the trim in the reverse order of removal, and note these items: - If the clip is damaged or stress-whitened, replace it with a new one.
- Push the clip, the hooks, and the hook strip into place securely.
4-door
NOTE: Take care not to scratch the door.
1. Remove the door panel (see page 20-17).
2. Lower the glass fully.
3. Remove the door sash inner trim (A).
-1. Detach the clip fastening the trim.
-2. Pull back along the outside edge of the trim to release the hooks or the hook strips (B) from the door glass opening flange at the A-pillar area and the roof area of the door sash.
-3. Release the hook (C) from the glass run channel (D) at the rear corner area of the door sash.
-4. Pull back along the outside edge of the trim to release the hooks or the hook strips (E) from the door glass opening flange at the B-pillar area of the door sash.
-5. Release the rear hook (F) from the door.
Japan-produced models
USA-produced models
4. Install the trim in the reverse order of removal, and note these items: - If the clip is damaged or stress-whitened, replace it with a new one.
- Push the clip, the hooks, and the hook strips into place securely.
Front Door Glass and Regulator Replacement
NOTE: Put on gloves to protect your hands. 1. Remove the door panel: - 2-door (see page 20-12) - 4-door {see page 20-17) 2.2-door: Remove the screws, then remove the door panel bracket (A). ...Front Door Sash Outer Trim Replacement
NOTE: - Take care not to scratch the door. - 4-door is shown; 2-door is similar. 1. Remove the door outer molding (see page 20-36). 2. Pull up the door sash outer trim (A) to release the ho ...See also:
Starter Removal and
Installation
Removal
1 Do the battery removal procedure (see page 22-92).
2. Remove the intake manifold (see page 9-4).
3. Disconnect the positive starter cable (A) from the B
terminal, and the S terminal ...
Menu Display
To select any setting such as the
clock, sound adjusting, or the
compass (if equipped), press the
MENU button. To use any audio
system function, the ignition switch
must be in the ACCESSORY ...
Seat
Driver's seat
- 4-door
2-door
Front passenger's seat
4-cfoor
2-door
...