Honda Accord: Front Door Outer Molding
Replacement - Doors - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Front Door Outer Molding Replacement

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Honda Tool and Equipment Program; call 888-424-6857

NOTE: - If you remove the door outer molding, replace it with a new one because it will bend during removal.

- Put on gloves to protect your hands.

- Take care not to scratch the door.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- 4-door is shown; 2-door is similar.

1 . Remove the power mirror (see page 20-62).

2. Detach the clip with a clip lemover, then pulf back the door weatherstrip (A), and remove the screw securing the door outer molding (B).

3. Pull out the upper edge of the door outer molding (A)


3. Pull out the upper edge of the door outer molding (A) from the edge of the sash, and cut the double-sided adhesive tape (B) with a utility knife, then remove the molding from the sash, and remove the molding from between the door glass outer weatherstrip (C) and the door.

4. Scrape off remaining double-sided adhesive tape


4. Scrape off remaining double-sided adhesive tape from the sash, then clean the sash surface with a shop towel dampened in isopropyl alcohol.

5. Install the door outer molding in the reverse order of removal, and note these items: - Insert the front edge of the molding between the door glass outer weatherstrip and the door properly.

- Push adhesive areas into place securely.

- Make sure the upper and lower sides of the molding are catching the edges of the sash properly.

- Push the clip into place securely.

    Front Door Glass Outer Weatherstrip Replacement
    NOTE: - Put on gloves to protect your hands. - Take care not to scratch the door. 1. Remove t h e s e Items: - Door panel - 2-door (see page 20-12) - 4-door (see page 20-17) - Plastic cover ...

    Front Door Weatherstrip Replacement
    NOTE: - Put on gloves to protect your hands. - Take care not to scratch the door. - Take care not to damage the front upper corner clip (black) (4-door) and the rear upper corner clips (black) ...

    See also:

    Shift Lever Removal
    1. Remove the center console (see page 20-158). 2. Move the shift lever to R. 3. Remove the nut securing the shift cable end. 4. Unlock the retainer (A). 5. Rotate the socket holder retain ...

    Transmission Housing
    Shaft Assembly and Housing Installation Exploded View NOTE: Refer to the Exploded View as needed during the following procedure. 1. Install the differential assembly in the torque converter ...

    Voice Control System
    The audio system can also be operated by voice control. See the navigation system manual for complete details. ...