Honda Accord: Front Air Spoiler Replacement
NOTE: -Take care not to scratch the front bumper, - Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove the clips securing the front air spoiler (A) from under the front bumper (B).
NOTE: To release the clips, pry up on the center pin at the notch (C).
2-door
4-door
2. Pull out the front air spoiler to detach the hooks (D), and remove the spoiler.
3. Install the spoiler in the reverse order of removal, and note these items: - If the clips are damaged or stress-whitened, replace them with new ones.
- Push the hooks and the clips into place securely.
Front Bumper Fog Light Cover
Replacement
2-door
NOTE; Take care not to scratch the front bumper.
1. Remove the front bumper (see page 20-255).
2. Remove the screws (A, B), then remove the front
bumper fog light cover (C) from the fro ...
Rear Bumper Removal/Installation
NOTE:
- Have an assistant help you when removing and
installing the rear bumper.
- Take care not to scratch the rear bumper or the body.
- Put on gloves to protect your hands.
- When prying ...
See also:
ECT Sensor 1 Replacement
1. Drain the engine coolant (see page 10-6).
2. Disconnect the ECT sensor 1 connector (A).
3. Remove ECT sensor 1 (B).
4. Install the parts in the reverse order of removal with a
new O-ring ...
Wheels
Clean the wheels as you would the
rest of the exterior. Wash them with
the same solution, and rinse them
thoroughly.
Aluminum alloy wheels have a
protective clear-coat that keeps the
alumin ...
System Description
The vehicle is equipped with a Type Vll (GEN 5) immobilizer system that will
disable the vehicle unless a programmed
ignition key is used.
This system consists of a transponder combined with a k ...