Trunk Lid Latch Replacement

Special Tools Required KTC Trim Too! Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Put on gloves to protect your hands. - Take care not t ...

Frame Brace Replacement

Strut Brace Replacement 1. Remove the cowl cover (see page 20-278). 2. Disconnect the brake booster vacuum hose (A) from the strut brace (B). 3. Remove the nuts from the top of the damper, and ...

See also:

ATF Pump Inspection
1. Install the ATF pump drive gear (A), the driven gear (B), and the ATF pump driven gear shaft (C) in the main valve body (D). Lubricate all parts with ATF, and install the ATF pump driven gear wi ...

Electrical Compass Zone Selection and Calibration
NOTE: • You should do this procedure any time the electrical compass unit is replaced. • You should do this procedure in an open area away from buildings, power lines, and other vehicl ...

Rear License Plate Light Bulbs
When replacing, use the following bulbs. 1. Remove the license plate light assembly by pushing the left edge of the lens toward the right and pulling the assembly out. 2. Remove the lens b ...