Honda Accord: Forced Starting of Display
Special Tools Required
SCS Service Connector 07PAZ-0010100
1. Turn the ignition switch to LOCK (0).
2. Connect the SCS service connector (A) to the navigation service connector (B) located behind the navigation unit.
3. Turn the ignition switch to ON (II).
4. Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the System Links menu.
NOTE: If the display fails to display the System Links screen, refer to no picture is displayed (see page 23-217).
Symptom Troubleshooting
No picture Is displayed
Diagnostic Test: Self-Diagnosis ModВ©
NOTE:
• Check the vehicle battery condition first (see page
• 22-90).
• Check button has been pressed,
and turn ...
DVD-ROM Replacement
NOTE:
• Check any official Honda service website for more
service information about the navigation system and
software updates.
• Do not replace the DVD to give a customer a preview
o ...
See also:
Piston, Pin, and Confyssfeg EQC
Replacement
Disassembly
1. Remove the piston from the engine block (see page
7-14).
2. Apply new engine oil to the piston pin snap rings (A),
and turn them in the ring grooves until the end gaps
are lined ...
Adjust the Head Restraints
Adjust the driver’s head restraint so
the center of the back of your head
rests against the center of the
restraint.
Have passengers adjust their head
restraints properly as well. Taller ...
Shift Lever Does Not Move
Follow the procedure below if you cannot move the shift lever out of the
position.
• Releasing the Lock
1. Set the parking brake.
2. Remove the key from the ignition switch.
2. Remove ...