Honda Accord: Exhaust Pipe and Muffler Replacement - Intake Manifold and Exhaust System - Engine Mechanical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Exhaust Pipe and Muffler Replacement

NOTE: Use new gaskets and self-locking nuts when reassembling.

Engine Cooling


    Intake Manifold Removal and Installation
    Exploded View Removal 1. Do the battery removal procedure (see page 22-92). 2. Remove the front grille cover: Р’В© 2-door (see page 20-274) Р’В© 4-door (see page 20-274) 3. Remove ...

    Engine Cooling
    ...

    See also:

    Wear Indicators
    The groove where the wear indicator is located is 1/16 inch (1.6 mm) shallower than elsewhere on the tire. If the tread has worn so that the indicator is exposed, replace the tire. Worn out ...

    Fuel Filter Replacement
    The fuel filter should be replaced whenever the fuel pressure drops below the specified value (see page 11-308), after making sure that the fuel pump and the fuel pressure regulator are OK. 1. R ...

    Secondary Shaft 2nd Gear Axial Clearance Inspection
    1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), t ...