Honda Accord: EVAP Canister Purge Valve
Replacement
1. Disconnect the E V A P canister purge valve 2P connector ( A ) .
2. Disconnect the hoses ( B ) , then remove the I V A P canister purge valve ( C ) .
3. Install the parts in the reverse order of removal.
EVAP Canister Vent Shut Valve
Replacement
1 o Disconnect the EVAP canister vent shut valve 2P
connector (A).
2. Remove the cap (B).
3. Remove the EVAP canister vent shut valve (C).
4. Install the parts in the reverse order of remova ...
Transaxle
...
See also:
Driver's Seat Position Sensor Replacement
Removal (Power seat)
NOTE: Do not t u r n t h e i g n i t i o n s w i t c h t o ON (II), a n d do
not connect t h e battery cable w h i l e r e m o v i n g t he
d r i v e r ' s seat p o s i t i o n ...
Fuel Cap Warning Message System
Troubleshooting
Special Tools Required
- Vacuum Pump/Gauge, 0 - 3 0 In.Hg, Snap-on YA4000A
or equivalent, commercially available
- Vacuum/Pressure Gauge, 0 - 4 In.Hg, 07JAZ-001000B
comes on frequently, or if the ...
Mode Control Motor Test
NOTE: Before testing the motor, check for HVAC DTCs
(see page 21-101).
1. Disconnect the 7P connector from the mode control
motor.
Incorrectly applying power and ground to the mode
control mo ...