Honda Accord: Engine Oil Replacement
1. Warm up the engine.
2 Remove the drain bolt (A), and drain the engine oil.
3. Reinstall the drain bolt with a new washer (B).
4. Refill the engine with the recommended oil (see page 3-2).
Capacity ('08-”09 models) At Oil Change: 4.0 L (4.2 US qt) At Oil Change Including Filter: 4.2 L (4.4 US qt) After Engine Overhaul: 5.3 L (5.6 US qt) Capacity ('10 model) At Oil Change: 3.3 L (4.0 US qt) At Oil Change Including Filter: 4.0 L (4.2 US qt) After Engine Overhaul: 5.1 L (5.4 US qt)
5. Run the engine for more than 3 minutes, then check for oil leakage.
6. If the maintenance minder reguired engine oil replacement, reset the maintenance minder (see page 3-4), and this procedure is complete. If the maintenance minder did not reguire engine oil replacement, go to step 7.
7. Turn the ignition switch to LOCK (0).
8 Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3).
9. Turn the ignition switch to ON (II).
10. Make sure the HDS communicates with the vehicle and the engine control module (ECM)/powertrain control module (PCM). If it does not communicate, troubleshoot the DLC circuit (see page 11-181).
11. Select GAUGES in the BODY ELECTRICAL with the HDS.
12. Select ADJUSTMENT in the GAUGES with the HDS.
13. Select MAINTENANCE MINDER in the ADJUSTMENT with the HDS.
14 Select RESET in the MAINTENANCE MINDER with the HDS.
15. Select RESETTING THE ENGINE OIL LIFE with the HDS.
NOTE: If you changed the automatic transmission fluid (ATF) at the same time with the engine oil, select RESETTING THE ENGINE OIL LIFE AND ATF with the HDS instead.
Engine Oil Lewel Check
1. Park the vehicle on level ground, and start the engine.
Hold the engine speed at 3,000 rpm with no load (in N
or P (A/T model) or Neutral (M/T model)) until the
radiator fan comes on, then tur ...
Engine Oil Filter Replacement
Special Tools Required
Oil Filter Wrench 07 AAA-PLC A100
1. Drain the engine oil (see page 8-11).
2. Remove the oil filter with the oil filter wrench.
3. Inspect the filter to make sure the ru ...
See also:
DTC Troubleshooting
DTC U0155: Immobilizer-keyless Control Unit
Lost Communication With Gauge Control
Module
NOTE: If you are troubleshooting multiple DTCs, be sure
to follow the instructions in B-CAN System Diagnosi ...
Connector Index
Identification numbers have been assigned to in-line connectors, junction
connectors, and terminals. The number is preceded by the letter "C"
for connectors, " G " for ground te ...
Modifications
Do not modify your vehicle or use non-Honda components that can affect its
handling, stability, and reliability.
Overall vehicle performance can be affected. Always make sure all equipment
is
p ...