Honda Accord: Engine Oil Lewel Check
1. Park the vehicle on level ground, and start the engine.
Hold the engine speed at 3,000 rpm with no load (in N or P (A/T model) or Neutral (M/T model)) until the radiator fan comes on, then turn off the engine, and wait a few minutes. 2. Remove the dipstick, and wipe off the dipstick, then reinstall the dipstick.
3. Remove the dipstick, and check the engine oil level. It should" be between the upper mark (A) and the lower mark (B).
4. If the engine oil level is nearer below the lower mark, add the recommended engine oil to bring it between the upper and lower marks.
Oil Pressure Test
NOTE: If the low oil pressure warning indicator stays on
with the engine running, check the engine oil level. If the
oil level is correct, do the following test.
1. With the engine stopped, remov ...
Engine Oil Replacement
1. Warm up the engine.
2 Remove the drain bolt (A), and drain the engine oil.
3. Reinstall the drain bolt with a new washer (B).
4. Refill the engine with the recommended oil (see page
3-2). ...
See also:
DTC Troubleshooting
DTC P0506: idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot record all freeze data
and any on-board snapshot, and review the general
troubleshooting information (see page ...
A/C Compressor Relief Valve
Replacement
1. Recover the refrigerant with a
recovery/recycling/charging station (see page 21-80).
2. Raise the vehicle on a lift.
3. Remove the relief valve (A) and the O-ring (B). Plug
the opening to k ...
Rear Bumper Removal/Installation
NOTE:
- Have an assistant help you when removing and
installing the rear bumper.
- Take care not to scratch the rear bumper or the body.
- Put on gloves to protect your hands.
- When prying ...