Honda Accord: Engine Oil Gallery Cap Replacement
1. Remove the harness bracket (A), then remove the engine oil gallery cap (B).
2. Clean the O-ring groove and mating surface with the engine oil gallery cap.
3. Apply new engine oil to new O-rings (C). Install the engine oil gallery cap with O-rings, then install the harness bracket.
Oil Filter Feed Pipe Replacement
1. Remove the oil filter base (see page 8-13).
2. Remove the oil filter feed pipe.
3. Install the two 20 x 1.5 mm nuts (A) onto the new oil
filter feed pipe. Hold one nut with a wrench, then us ...
Oil Jet Replacement
1. Remove the oil pump (see page 8-17).
2. Remove the baffle plate (see step 8 on page 7-14).
3. Remove the oil jet bolts (A), then remove the oil jets
(B).
4. Carefully install the oil jets ...
See also:
Windshield Washers
Check the level in the windshield
washer reservoir at least monthly
during normal use.
Check the fluid level by removing
the cap and looking at the level
gauge.
On Canadian models: The low ...
Special Tools
...
Climate Control Power and Ground
Circuit Troubleshooting
1. Check the No. 16 (7.5 A) fuse in the driver's
under-dash fuse/ relay box.
is the fuse OK?
YES-Go to step 2.
NO-Replace the fuse, and recheck. If the fuse blows
again, check for a short in ...