Honda Accord: Engine Lubrication
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Engine Mechanical / Engine Lubrication
- Special Tools
- Component Location Index
- Symptom Troubleshooting Index
- Low Oil Pressure Indicator Circuit Diagram
- Low Oil Pressure Indicator Circuit Troubleshooting (Open)
- Low Oil Pressure Indicator Circuit Troubleshooting (Short)
- Oil Pressure Switch Test
- Oil Pressure Switch Replacement
- Oil Pressure Test
- Engine Oil Lewel Check
- Engine Oil Replacement
- Engine Oil Filter Replacement
- Oil Filter Base Replacement
- Oil Filter Feed Pipe Replacement
- Engine Oil Gallery Cap Replacement
- Oil Jet Replacement
- Oil Pump Overhaul
- Balancer Shaft Inspection
- Oil Pump Chain inspection
- Oil Pump Chain Replacement
Sealing Bolt Installation
NOTE: When installing the sealing bolt (A), always use a
new washer.
...
Special Tools
...
See also:
Sleep and Wake-up Mode Test
1. Shift to the sleep mode:
Close all doors. Turn the ignition switch to LOCK (0), and remove the key, then
open and close the driver's door. If the
MICU receives no further inputs listed below, i ...
Piston Installation
If the Crankshaft is Already Installed
1. Set the crankshaft to bottom dead center (BDC) for
each cylinder as its piston is installed.
2. Remove the connecting rod caps, then install the ring
co ...
Daytime Running Lights
The high beam headlights come on slightly dimmer than normal when the
following
conditions have been met:
The parking/daytime running lights come on when the following conditions have
been ...