Honda Accord: Engine Block
- Special Tools
- Component Location Index
- Connecting Rod and Crankshaft End Play Inspection
- Crankshaft Main Bearing Replacement
- Connecting Rod Bearing Replacement
- Oil Pan Remowal
- Crankshaft and Piston Remowal
- Crankshaft Inspection
- Block and Piston inspection
- Cf Hinder Bore Honing
- Piston, Pin, and Confyssfeg EQC Replacement
- Piston Ring Replacement
- Piston Installation
- Connecting Rod Bolt Inspection
- Crankshaft Installation
- CKP Pulse Plate Replacement
- Oil Pan Installation
- Transmission End Crankshaft Oil Seal Installation - In Car.
- Sealing Bolt Installation
Sealing Bolt Installation
NOTE: When installing the sealing bolt, always use a
new washer.
...
Special Tools
...
See also:
Refueling
1. Park with the driver’s side closest
to the service station pump.
2. To open the fuel fill door, push
down on the lever located to the
left of the driver’s seat.
Gasoline is highly f ...
Transmission Fluid Pressure Switch A
(2nd Clutch) Replacement
1. Remove the intake air duct.
2. Disconnect the connector (A) from the transmission
fluid pressure switch A (2nd clutch) (B), and remove
the transmission fluid pressure switch A (2nd clutch).
...
Shift Lock Stop/Shift Lock Stop Cushion
Replacement
Type A Shift Lever
1. Remove the shift lock solenoid (see page 14-254).
2. Remove the shift lock stop (A) and the stop cushion
(B) as a set.
3. Apply silicone grease to the pin (C) of the shif ...