Engine Mechanical

Special Tools

See also:

Active Noise Cancellation Microphone Removal/Installation
Front 1. Remove the roof console (see page 20-140), and disconnect the connector (A) from the front active noise cancellation microphone (B). 2. Remove the screws and the front active noise can ...

Emissions Testing
Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘ ...

Secondary H02S Replacement
Special Tools Required 02 Sensor Wrench Snap-on S6176 or equivalent, commercially available 1. Disconnect the secondary H02S 4P connector (A), then remove the secondary H02S (B). 2. Install the ...