Honda Accord: Eighth generation (2008–2012)
The North American version of the Accord has a different body from its Japanese counterpart. This shape is sold as the Honda Inspire in Japan, and is not sold in Europe. It was discontinued in Japan in September 2012. Larger than the previous model, the sedan is now classified as a full-size car by EPA standards. A coupe version is available, as well as a Crosstour fastback model, which was introduced in the US for the 2010 model year.
- Honda Accord 2008-2012 Owner's Manual
- Introduction
- A FewWordsAbout Safety
- Overview of Contents
- Your Vehicle at a Glance
- Driver and Passenger Safety
- Instruments and Controls
- Features
- Before Driving
- Driving
- Maintenance
- Taking Care of the Unexpected
- Technical Information
- Warranty and Customer Relations
- Honda Accord MK8 2008-2012 Service Manual
- Introduction
- Supplemental restraint system (SRS)
- General Information
- Specifications
- Maintenance
- Engine Electrical
- Engine Mechanical
- Fuel and Emissions
- Transaxle
- Transaxle
- Transaxle
- Introduction
- Supplemental restraint system (SRS) (if steering maintenance is required)
- Steering
- Suspension
- Brakes
- Body
- Heating, Ventilation, and Air Conditioning
- Body Electrical
- Audio, Navigation, and Telematics
- Restraints
Seventh generation (2003–2007)
The seventh generation of the Accord was launched in 2002 (2003 model year in North America), and consists of two separate models; one for the Japanese and European markets, and the other for North Am ...
Ninth generation (2013–2026)
For the ninth-generation Accord, Honda appointed Shoji Matsui, who served as an engineer on the Accord platform from 1985 to 1996 as lead project manager. It is the first Accord to use a strut suspens ...
See also:
Sealing Bolt Installation
NOTE: When installing the sealing bolt (A), always use a
new washer.
...
Tie-rod End Ball Joint Boot Replacement
Special Tools Required
Bearing Driver Attachment, 36 07965-SA50500
1 Disconnect the tie-rod end ball joint from the knuckle
(see step 26 on page 17-41).
2. Remove the tie-rod end from the rack e ...
Outside Air Temperature Sensor Test
NOTE: Before testing the sensor, check for HVAC DTCs
(see page 21-101):.
1. Remove the outside air temperature sensor (seepage'
21-185).
2. Dip the sensor in ice water, and measure the
resist ...