Honda Accord: ECT Sensor 2 Replacement - PGM-FI System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: ECT Sensor 2 Replacement

1. Remove the front splash shield, (see page 20-291) 2. Drain the engine coolant (see page 10-6).

3. Disconnect the ECT sensor 2 connector (A), then remove ECT sensor 2 (B).

4. Install ECT sensor 2 with a new O-ring (C).


4. Install ECT sensor 2 with a new O-ring (C).

5. Install the front splash shield, (see page 20-291) 6. Refill the radiator with engine coolant (see page 10-6).

    ECT Sensor 1 Replacement
    1. Drain the engine coolant (see page 10-6). 2. Disconnect the ECT sensor 1 connector (A). 3. Remove ECT sensor 1 (B). 4. Install the parts in the reverse order of removal with a new O-ring ...

    Output Shaft (Countershaft) Speed Sensor Replacement
    NOTE: For A/T models (see page 14-188). M/T 1. Disconnect the output shaft (countershaft) speed sensor 3P connector (A). 2. Remove the output shaft (countershaft) speed sensor (B). 3. Instal ...

    See also:

    Component Location Index
    ...

    ATF Replacement
    NOTE: Keep all foreign particles out of the transmission. 1. Park the vehicle on level ground. 2. Warm up the engine to normal operating temperature (the radiator fan comes on), and turn the en ...

    Special Tools
    ...