Honda Accord: ECT Sensor 1 Replacement - PGM-FI System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: ECT Sensor 1 Replacement

1. Drain the engine coolant (see page 10-6).

2. Disconnect the ECT sensor 1 connector (A).

3. Remove ECT sensor 1 (B).


3. Remove ECT sensor 1 (B).

4. Install the parts in the reverse order of removal with a new O-ring (C), then refill the radiator with engine coolant (see page 10-6).

    MAF Sensor/IAT Sensor Replacement
    1. Disconnect the MAF sensor/IAT sensor connector (A). 2. Remove the screws (B). 3. Remove the MAF sensor/IAT sensor (C). 4. Install the parts in the reverse order of removal with a new O-ri ...

    ECT Sensor 2 Replacement
    1. Remove the front splash shield, (see page 20-291) 2. Drain the engine coolant (see page 10-6). 3. Disconnect the ECT sensor 2 connector (A), then remove ECT sensor 2 (B). 4. Install ECT sen ...

    See also:

    Opening and Closing the Hood
    1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the ho ...

    Clutch
    ...

    Countershaft Reassembly
    Exploded View *: The components of the triple cone synchro assembly. Special Tools Required -СћDriver Handle, 40 mm I.D. 07746-0030100 - Bearing Driver Attachment, 30 mm 07746-0030300 NOTE: R ...