Honda Accord: ECM/PCM Idle Learn Procedure - Idle Control System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: ECM/PCM Idle Learn Procedure

The idle learn procedure must be done so the ECM/PCM can learn the engine idle characteristics.

Do the idle learn procedure whenever you do any of these actions:

 - Replace ECM/PCM.

 - Reset ECM/PCM

 - Update ECM/PCM.

 - Replace or clean the throttle body.

 - Disassemble the engine or the transmission.

NOTE: Erasing DTCs with the HDS does not require you to do the idle learn procedure.

Procedure

1. Make sure all electrical items (A/C, audio, lights, etc.) are off.

2. Reset the ECM/PCM with the HDS.

3. Turn the ignition switch to ON (II), and wait 2 seconds.

4. Start the engine. Hold the engine speed at 3,000 rpm without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, or until the engine coolant temperature reaches 194 Р’В°F (90 Р’В°C).

5. Let the engine idle for about 5 minutes with the throttle fujly closed.

NOTE: If the radiator fan comes on, do not include its running time in the 5 minutes.

    Idle Speed Inspection
    NOTE: - Before checking the idle speed, check these items:  - The malfunction indicator lamp (MIL) has not been reported on, and there are no DTCs.  - Ignition timing  - Spark plug ...

    Fuel Supply System
    ...

    See also:

    Front Passenger's Power Window Switch Replacement
    4-door 1. Carefully remove the front passenger's power window switch (A). 2. Disconnect the 37P connector (B) from the front passenger's power window switch. 3. Remove the four screws and th ...

    Vehicle Stability Assist (VSA ), aka Electronic Stability Control (ESC), System
    The vehicle stability assist (VSA) system helps to stabilize the vehicle during cornering if the vehicle turns more or less than desired. It also assists you in maintaining traction while ac ...

    Front Passenger's Weight Sensor Output Check After a Vehicle Collision
    1. Position the front passenger's seat to the rear most position, and adjust the seat-back to the forward most position. Do not move the seat from this position. 2. Drive the vehicle, accelerate ...