Honda Accord: Dynamic Damper Replacement - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Dynamic Damper Replacement

1. Remove the Inboard joint (see page 16-7).

2. Remove the dynamic damper band (see step 1 on page 16-7).

3. Remove the dynamic damper (A).

Left driveshaft

Right driveshaft


Right driveshaft

4. Install a new dynamic damper.


4. Install a new dynamic damper.

NOTE; Be careful not to swap the dynamic dampers.

Check the type of dynamic damper by its shape.

5. Adjust the specified distance (A) between the outboard joint side and the dynamic damper edge.

NOTE: Check the type of dynamic damper by its shape.

Left driveshaft

A: 298.5-303.5 mm (11.75-11.95 in)

Right driveshaft


Right driveshaft

A: 292.5-297.5 mm (11.52-11.71 in)

6. Install the dynamic damper band (see step 10 on page


6. Install the dynamic damper band (see step 10 on page 16-14).

7. Install the inboard joint (see page 16-12).

    Driveshaft Disassembly
    Special'Tools Required •Threaded Adapter, 26 x 1.5 mm 07XAC-001030A -Slide Hammer 5/8M-18 UNF, commercially available -Bearing Puller, commercially available -Boot Band Pliers, commercially ...

    Driveshaft Reassembly
    Exploded View Special Tools Required -Boot Band Tool KD-3191 or equivalent, commercially available •Seal Clamp Tool Kent-Moore J-35910 or equivalent, commercially available -Boot Band P ...

    See also:

    Heating and Cooling System*/ClimateControl System* Maintenance
    Dust and Pollen Filter The heating and cooling system*/climate control system* is equipped with a dust and pollen filter that collects pollen, dust, and other debris in the air. The Maintenance ...

    Servo Body Disassembly, Inspection, and Reassembly
    1. Clean all parts thoroughly in solvent, and dry them with compressed air. Blow out all passages. 2. Inspect the valve body for scoring and damage. 3. Check shift valve D for free movement. I ...

    Circuit Diagram
    ...