Honda Accord: Dust and Pollen Filter Replacement
1. Open the glove box. Remove the glove box stop on the right side, then let the glove box hang down (see page 20-174).
2. Remove the dust and pollen filter assembly (A) from the blower unit.
3. Remove the filter (A) from the housing (B), and replace the filter.
4. Install the filter in the reverse order of removal. Make sure that there is no air leaking out of the blower unit.
Receiver/Dryer Desiccant
Replacement
NOTE: Install the receiver/dryer as quickly as possible to
prevent the system from absorbing moisture from the
air.
1. Remove the A/C condenser (see page 21 -77).
2. Remove the bolts from the ...
Refrigerant Recovery
• Air conditioning refrigerant or lubricant vapor can
irritate your eyes, nose, or throat.
• Be careful when connecting service
equipment.
•Do not breathe refrigerant or vapor. ...
See also:
Installing a Child Seat with LATCH
Your vehicle is equipped with
LATCH (Lower Anchors and
Tethers for CHildren) at the outer
rear seats.
The lower anchors are located
between the seat-back and seat
bottom, and are to be used ...
Sleep and Wake-up Mode Test
1. Shift to the sleep mode:
Close all doors. Turn the ignition switch to LOCK (0), and remove the key, then
open and close the driver's door. If the
MICU receives no further inputs listed below, i ...
Idler Gear Shaft Bearing Replacement
Special Tools Required
-Adjustable Bearing Puller, 25—40 mm 07736-A01000B
•Driver Handle, 15 x 135L 07749-0010000
-Attachment, 52 x 55 mm 07746-0010400
1. Remove the idler gear shaft be ...