Honda Accord: DTC Troubleshooting Index
NOTE: Before you troubleshoot record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information (see page 14-4).
NOTE:
*1: The DTC in parentheses is the flash code the D indicator indicates when the data link connector (DLC) is connected to the HDS, and in the SCS mode.
*2: This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
*3: The MIL comes on when the PGM-FI system detects the same failure.
*4: '08-09 models
*5: '10 model
NOTE:
*1: The DTC in parentheses is the flash code the D indicator indicates when the data link connector (DLC) is connected to the HDS, and in the SCS mode.
*2: This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
*3: The MIL comes on when the PGM-FI system detects the same failure.
*4: '08-09 models
*5: '10 model
NOTE:
*1: The DTC in parentheses is the flash code the D indicator indicates when the data link connector (DLC) is connected to the HDS, and in the SCS mode.
*2: This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
*3: The MIL comes on when the PGM-FI system detects the same failure.
*4: '08-09 models
*5: '10 model
NOTE:
*1: The DTC in parentheses is the flash code the D indicator indicates when the data link connector (DLC) is connected to the HDS, and in the SCS mode.
*2: This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
*3: The MIL comes on when the PGM-FI system detects the same failure.
*4: '08-09 models
*5: '10 model
General Troubleshooting Information
How to Check for DTCs with the Honda
Diagnostic S f stem (HDS)
When the powertrain control module (PCM) senses an
abnormality in the input or output system, the D
indicator (A) in the gauge contro ...
Symptom Troubleshooting Index
NOTE: Do an all DTC check with the HDS and troubleshoot those first before
following the repair procedures listed in the
index.
...
See also:
Rocker Arm Oil Pressure Switch
Removal/Installation
All models except PZEV
1. Disconnect the rocker arm oil pressure switch
connector (A).
2. Remove the rocker arm oil pressure switch (B).
3. Install the parts in the reverse order of removal wi ...
Vehicle Stability Assist (VSA ), aka Electronic Stability
Control (ESC), System
The vehicle stability assist (VSA)
system helps to stabilize the vehicle
during cornering if the vehicle turns
more or less than desired. It also
assists you in maintaining traction
while ac ...
Rear License Plate Light Bulbs
When replacing, use the following bulbs.
1. Remove the license plate light assembly by
pushing the left edge of the lens toward the
right and pulling the assembly out.
2. Remove the lens b ...