Compass Zone Selection

1. Set the power mode to ON. 2. On the top screen of any audio source, press and hold   for 5 seconds.  - The display switches to the Compass Settings screen. 3. Rotate to sele ...

Before Driving

...

See also:

Countershaft Inspection
1. Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace it. ...

Low Oil Pressure Indicator Circuit Troubleshooting (Open)
1 Connect the Honda Diagnostic System (HDS) to the data Jink connector (DIG) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (ll). 3. Make sure the HDS communicates with the vehicl ...

Component Location I n d e x
All models except PZEV ...