Honda Accord: Driveshaft Reassembly - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Driveshaft Reassembly

Exploded View

Special Tools Required


Special Tools Required

-Boot Band Tool KD-3191 or equivalent, commercially available

•Seal Clamp Tool Kent-Moore J-35910 or equivalent, commercially available

-Boot Band Pliers, commercially available

NOTE: Refer to the Exploded View, as needed, during this procedure.

Dynamic Damper Replacement
1. Remove the Inboard joint (see page 16-7). 2. Remove the dynamic damper band (see step 1 on page 16-7). 3. Remove the dynamic damper (A). Left driveshaft Right driveshaft 4. Install a ...

Inboard Joint Side
1. Wrap the splines with on the driveshaft vinyl tape (A) to prevent damaging the inboard boot. 2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to dama ...

See also:

Air Mix Control Motor Replacement
1. Remove the driver's dashboard undercover (see page 20-170). 2. Disconnect the 7P connector (A) from the air mix control motor (B). Remove the self-tapping screws and the air mix control motor ...

Cellular Phonebook
(available on some phones) On models with navigation system If you select Cellular Phone from the Information screen menu, you will see five HFL options. For a list of cell phones that are co ...

A/C Compressor Relief Valve Replacement
1. Recover the refrigerant with a recovery/recycling/charging station (see page 21-80). 2. Raise the vehicle on a lift. 3. Remove the relief valve (A) and the O-ring (B). Plug the opening to k ...