Honda Accord: Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and the boot bands.
2. Check the driveshaft for cracks and damage. If any damage is found, replace the driveshaft.
3. Check the inboard joint (E) and the outboard joint (F) for cracks and damage. If any damage is found, replace the inboard joint or the outboard joint as an assembly.
4. Hold the inboard joint and turn the front wheel by hand, then make sure the joint is not excessively loose. If necessary, replace the inboard joint or the outboard joint as an assembly.
Driveshaft Removal
Special Tools Required
-Ball Joint Thread Protector, 14 mm 07AAE-SJAA100
-Ball Joint Remover, 28 mm 07MAC-SL0A202
1. Raise and support the vehicle, (see page 1-13)
2. Remove the front wheels.
3 ...
See also:
Speaker Test/Replacement
Front Door Speaker
1. Remove the door panel.
• 4-door (see page 20-17)
• 2-door (see page 20-12)
2. Remove t h e bolt (A). Then lift the speaker straight up
to release t h e lower cli ...
Oil Pump Chain inspection
1. Remove the oil pan (see page 7-11).
2. Measure the oil pump chain auto-tensioner rod
length. If the length is over the service limit, replace
the oil pump chain (see page 8-25).
Oil Pump Chai ...
HFL Menus
The ignition switch must be in ACCESSORY or ON to use HFL.
• Phone Settings screen
To use HFL, you must first pair your Bluetoothcompatible
cell phone to the system while the vehicle
is ...