Honda Accord: Driver's Inner Middle Pad
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
* Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE: -Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove these items: - Center pocket: - Without navigation system (see page 20-168) -With navigation system (see page 20-169) - Driver's inner dashboard trim (see page 20-167) - Passenger's dashboard trim (see page 20-173) - Dashboard center vent (with navigation system) (see page 20-178) - Audio-HVAC module: - Without navigation system (see page 23-115) - With navigation system (see page 21-190) 2. Gently pull out along the edge of the driver's inner middle pad (A) to release the hooks (B)r then remove the pad.
3. Install the pad in the reverse order of removal, and push the hooks into place securely.
Driver's Outer Middle Pad
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the dashboard or the related
pa ...
Passenger's Middle Pad
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component ...
See also:
Under-hood Fuse/Relay Box
Removal and Installation
Special Tools Required
Relay Puller 07AAC-000A1A0
NOTE; The under-hood fuse/relay box is a part of the left
engine compartment wire harness, and it cannot be
replaced by ...
DTC Troubleshooting Index
Checking the DTCs by HDS
*:'10 model ...
Intermediate Shaft Removal
1. Drain the transmission fluid. Reinstall the drain plug
using a new sealing washer:
-Manual transmission (see page 13-5)
-Automatic transmission (see page 14-192)
2. Remove the right driveshaft ...