Honda Accord: Drive Plate Removal and Installation - Automatic Transmission - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Drive Plate Removal and Installation

1. Remove the transmission assembly (see page 14-194).

2. Remove the drive plate (A) and the washer (B) from the engine.

3. Install the drive plate and the washer on the engine,


3. Install the drive plate and the washer on the engine, and tighten the eight bolts in a crisscross pattern in at least two steps.

4. Install the transmission assembly (see page 14-205).

    Transmission Removal
    Special Tools Required -Engine Hanger Adapter VSB02C000015* -Engine Support Hanger, A and Reds AAR-T1256* - Subframe Adapter VSB02C000016* *: Available through the Honda Tool and Equipment Progra ...

    Transmission Installation
    Special Tools Required -Engine Hanger Adapter VSB02C000015* •Engine Support Hanger, A and Reds AAR-T1256* -Subframe Adapter VSB02C000016 -Subframe Alignment Pin 070AG-SJAA10S *: Available ...

    See also:

    Compass Zone Selection
    1. Set the power mode to ON. 2. On the top screen of any audio source, press and hold   for 5 seconds.  - The display switches to the Compass Settings screen. 3. Rotate to sele ...

    Reporting Safety Defects
    In the U.S. If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administratio ...

    Receiver/Dryer Desiccant Replacement
    NOTE: Install the receiver/dryer as quickly as possible to prevent the system from absorbing moisture from the air. 1. Remove the A/C condenser (see page 21 -77). 2. Remove the bolts from the ...