Honda Accord: Door Lock Knob Switch Test
Driver's Door
1. Remove the driver's door panel (see page 20-17).
2. Disconnect the 10P connector (A) from the door lock actuator (B).
3. Check for continuity between the terminals.
• There should be continuity between terminals No. 6 and No. 5 when the door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.
• There should be continuity between terminals No. 7 and No. 5 when the door lock knob switch is in the UNLOCK position and no continuity when the switch is in the LOCK position.
4. If the continuity is not as specified, replace the door lock actuator.
Passenger Doors (With Security)
1. Remove the passenger's door panel.
• Front (see page 20-17) • Rear (see page 20-38) 2. Disconnect the 10P connector (A) from the door lock actuator (B).
3. Check for continuity between the terminals.
There should be continuity between terminals No. 8 [No. 7] and No. 10 [No. 5] when the door lock knob switch in the UNLOCK position and no continuity when the switch is in the LOCK position.
[ ] : Left rear door
4. If the continuity is not specified, replace the door lock actuator.
Door Lock Actuator Test
Driver's Door and Left Rear Door (4-door)
1 Remove the door panel.
• Front (see page 20-17)
• Rear (see page 20-38)
2. Disconnect the 10P connector (A) from the actuator
(B).
NOTE: T ...
Door Key Cylinder Switch Test
1. Remove the driver's door panel (see page 20-17).
2. Disconnect the 10P connector (A) from the door lock
actuator (key cylinder switch) (B).
3. Check for continuity between the terminals.
...
See also:
Information
This chapter includes your vehicle's specifications, locations of
identification numbers, and other
information required by regulation. ...
Information Display
The information display shows the odometer, trip meter, engine oil life and
maintenance service item codes, and other gauges.
• Switching the Display
Press the (Select/Reset) knob to
change th ...
Rear Power Window Switch
Test/Replacement
1. Carefully remove the rear power window switch (A).
2. Disconnect the 14P connector (B) from the rear power
window switch.
3. Remove the three screws and the rear power window
switch (A).
...