Honda Accord: Differential Carrier/Final Driven Gear Replacemen
1. Loosen the bolts in a crisscross pattern in several steps, then remove the bolts and the final driven gear (A) from the differential carrier (B).
2. Install the final driven gear with the chamfer on the inside diameter facing the carrier. Tighten the bolts in a crisscross pattern in several steps.
Backlash Inspection
1. Place the differential assembly on V-blocks (A), and
install the intermediate shaft (B) and the left driveshaft
(C).
2. Measure the backlash of both pinion gears (D) with a
dial indicator (E) ...
Carrier Bearing Replacement
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
1. Check the carrier bearings for wear and rough
rotation. If they rotate smoothly and their rollers show
no signs of wear, the beari ...
See also:
Track Repeat
To replay the current track
continuously, select TRACK
REPEAT, and press ENTER on the
interface selector. As a reminder,
you will see REPEAT next to
TRACK on the screen. To turn this
featu ...
Remote Transmitter
LOCK - Press this button once to
lock both doors. Some exterior lights
will flash once. When you push
LOCK twice within 5 seconds, you
will hear a beep to verify that the
doors are locked ...
In-car Temperature Sensor Test
NOTE: Before testing the sensor, check for HVAC DTCs
(see page 21-101).
1. Remove the in-car temperature sensor (see page
21-184).
2. Test the in-car temperature sensor while holding it in
fr ...