Honda Accord: Differential Carrier and Final Driven
Gear Replacement - A/T Differential - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Differential Carrier and Final Driven Gear Replacement

Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Transaxle / A/T Differential / Differential Carrier and Final Driven Gear Replacement

1. Remove the final driven gear (A) from the differential carrier (B).

NOTE: Differential carrier bolts have left-hand threads.

2. Install the final driven gear in the direction shown on


2. Install the final driven gear in the direction shown on the differential carrier.

3. Secure the final driven gear and the differential carrier with the bolts. Tighten the bolts to the specified torque in a crisscross pattern in at least two steps.

    Carrier Bearing Replacement
    Special Tools Required Attachment, 40 x 50 mm 07LAD-PW50601 NOTE: -The bearing and the bearing outer race should be replaced as a set. -Inspect and adjust the carrier bearing preload wheneve ...

    Oil Seal Replacement
    Special Tools Required •Driver Handle, 15 x 135L 07749-0010000 •Oil Seal Driver Attachment 07947-SD90101 -Oil Seal Driver Attachment 07JAD-PH80101 1. Remove the oil seal from the transmi ...

    See also:

    In-car Temperature Sensor Test
    NOTE: Before testing the sensor, check for HVAC DTCs (see page 21-101). 1. Remove the in-car temperature sensor (see page 21-184). 2. Test the in-car temperature sensor while holding it in fr ...

    Component Location Index
    2-door 4-door ...

    Center Display Visor Removal / Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 Without Navigation System NOTE: - Take care not to scratch the d ...