Honda Accord: Dashboard Center Vent Removal / Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and Equipment Program; call 888-424-6857
With Navigation Sf stem
NOTE: - Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Apply protective tape (A) to the dashboard middle pad beside both side edges of the dashboard center vent (B). Pry up on the edge of the center vent with the appropriate trim tool to detach the clips (C, D).
2. Pull out the dashboard center vent (A) by hand to detach lower clips and release the projections (B) from the holes in the center display visor (C), then remove the center vent.
3. Disconnect the hazard warning switch/passenger's airbag cutoff indicator connector (D) and the navigation subdisplay connector (E). Detach the harness clip (F), and release the wire harness (G) from the harness holder (H).
4. Install the center vent in the reverse order of removal, and note these items: - If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Push the harness clip and the clips into place securely.
Dashboard Side Vent Removal/Installation
Special Tools Required KTC Trim Tool Set SOJATP2014* * Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE; - Take care not to scratch the dashboard or the related p ...Side Defogger Vent Trim Removal/Installation
Special Tools Required KTC Trim Tool Set SOJATP2014* * Available through the Honda Tool and Equipment Program; call 888-424-6857 Driver's Side NOTE: - Take care not to scratch the dashboard or ...See also:
Fuel Line/Quick-Connect Fitting
Precautions
The fuel line/quick-connect fittings (A, B, C, D, E, and F)
connect the fuel rail (G) to the fuel feed hose (H), the fuel
feed hose to the fuel line (I), the fuel line (J) to the fuel
tank unit (K) ...
Emissions Testing
Testing of Readiness Codes
Your vehicle uses “readiness codes,” as part of its onboard self diagnostic
system.
Some states refer to these codes during testing to see if your vehicle's
emis ...
DTC Troubleshooting
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot record all freeze data
and any on-board snapshot and review the general
troubleshooting Information (see page 11 ...