Honda Accord: Dashboard
- Instrument Visor Removal/Installation
- Driver's Dashboard Lower Cover Removal/Installation
- Driver's Outer Dashboard Trim Removal/Installation
- Driver's Inner Dashboard Trim Removal/Installation
- Center Pocket Removal/Installation
- Dashboard Center Lower Cover Removal/Installation
- Center Display Visor Removal / Installation
- Passenger's Dashboard Trim Removal/Installation
- Glove Box Lock Cylinder Replacement
- Glove Box Removal/Installation
- Glove Box Striker Replacement
- Dashboard Side Vent Removal/Installation
- Dashboard Center Vent Removal / Installation
- Side Defogger Vent Trim Removal/Installation
- Driver's Outer Middle Pad Removal/Installation
- Driver's Inner Middle Pad Removal/Installation
- Passenger's Middle Pad Removal/Installation
- Column Cover Removal/Installation
- Dashboard/Steering Hanger Beam Removal/Installation
- Dashboard/Steering Hanger Beam Disassembly/Reassembly
Accessory Power Socket Trim
Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the console.
- Use the approp ...
Instrument Visor Removal/Installation
Special Tools Required
KTC Trim Too! Set SOJATP2014*
*Available through the Honda Tool a n d Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the dashboard or the related
pa ...
See also:
Symptom Troubleshooting
No picture Is displayed
Diagnostic Test: Self-Diagnosis ModВ©
NOTE:
• Check the vehicle battery condition first (see page
• 22-90).
• Check button has been pressed,
and turn ...
General Troubleshooting
Information
Mow to Check for DTCs with the HDS
NOTE: Check the vehicle battery condition first {see page 22-90).
1. Make sure the ignition switch is turned to LOCK (0).
2. Connect the HDS to the data link ...
Housing and Shaft Assembly Removal
Special Tools Required
Housing Puller 07HAC-PK40102
1. Remove the ATF feed pipe (A) from the idler gear shaft, and remove the ATF
lubrication pipe (B) from the
transmission housing.
2. Remove ...