Honda Accord: Crossover Network Control Unit
Removal/Installation
Driver's Door Speaker Crossover Network Control Unit
1. Remove the driver's dashboard lower cover (see page 20-166).
2. Disconnect the connector (A), then remove the driver's door speaker crossover network control unit (B).
3. install the driver's door speaker crossover network control unit in the reverse order of removal.
Front Passenger's Door Speaker Crossover Network Control Unit
1. Remove the center console panel (see page 20-157), then remove the audio pocket (see page 20-168).
2. Disconnect the connector (A), then remove the passenger's door speaker crossover network control unit (B).
3. Install the passenger's door speaker crossover network control unit in the reverse order of removal.
Active Noise Cancellation
Microphone
Removal/Installation
Front
1. Remove the roof console (see page 20-140), and
disconnect the connector (A) from the front active
noise cancellation microphone (B).
2. Remove the screws and the front active noise
can ...
Speaker Test/Replacement
Front Door Speaker
1. Remove the door panel.
• 4-door (see page 20-17)
• 2-door (see page 20-12)
2. Remove t h e bolt (A). Then lift the speaker straight up
to release t h e lower cli ...
See also:
Audio/Information Screen
Displays the audio status and wallpaper. From this screen, you can go to
various
setup options.
• Switching the Display
Press the DISP button to go to the Function Change screen.
Ro ...
Gauge Control Module Input Test
NOTE: Before testing, do the gauge control module self-diagnosis function
(see page 22-332), and make sure the B-CAN
communication lines are OK.
1. Turn the ignition switch to LOCK (0).
2. Re ...
Information Display
Information Display
The information display shows the
odometer, trip meter, engine oil life,
outside temperature (if equipped),
and maintenance item code(s).
To switch the display, press and ...