Honda Accord: Countershaft Bearing Replacement - Torque Converter Housing - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Countershaft Bearing Replacement

Special Tools Required

-Adjustable Bearing Puller, 2 5 - 4 0 mm 07736-A01000B

-Driver Handle, 15 x 135L 07749-0010000

-Attachment, 62 x 68 mm 07746-0010500

1. Remove the countershaft bearing using the 25—40 mm adjustable bearing puller and a commercially available 3/8 "-16 slide hammer (A).

2. Remove the ATF guide plate (A), and check it for wear


2. Remove the ATF guide plate (A), and check it for wear and damage. If the guide plate is worn or damaged, replace it.

3. Install the ATF guide plate in the torque converter


3. Install the ATF guide plate in the torque converter housing, and install a new countershaft bearing (B).

4. Install the countershaft bearing securely in the torque converter housing using the driver handle and the 62 x 68 mm attachment.

5. Make sure that the bearing outer race notch-cut (A) is


5. Make sure that the bearing outer race notch-cut (A) is installed at a height of 0—0.05 mm (0—0.002 in) (B) above the torque converter housing surface (C). Do not install the countershaft bearing higher than 0.05 mm (0.002 in) above the torque converter housing surface.

Secondary Shaft Bearing


    Mainshaft Bearing and Oil Seal Replacement
    Special Tools Required -Adjustable Bearing Puller, 2 5 - 4 0 mm 07736-A01000B -Driver Handle, 15 x 135L 07749-0010000 -Attachment, 62 x 68 mm 07746-0010500 -Attachment, 72 x 75 mm 07746-0010600 1 ...

    Secondary Shaft Bearing Replacement
    Special Tools Required •Driver Handle, 15 x 135L 07749-0010000 •Attachment, 62 x 68 mm 07746-0010500 1. Remove the set plate bolt, then remove the lock washer (A) and the bearing set pla ...

    See also:

    Driving Preparation
    Check the following items before you start driving. • Exterior Checks • Make sure there are no obstructions on the windows, door mirrors, exterior lights, or other parts of the vehicle. &nbs ...

    Headlight Replacement
    4-door 1. Remove the parts shown. • Upper fender trim (see page 20-277) • Front bumper (see page 20-255) • Front bumper absorber (see page 20-255) 2. Remove the three bolts, and ...

    ATF Filter Replacement
    NOTE: The ATF filter is not a scheduled maintenance item. Replace the filter only if it is leaking, or contaminated, or when the transmission is being overhauled or replaced with a remanufactured u ...