Honda Accord: Conventional Brake Components
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Brakes / Conventional Brake Components
- Special Tools
- Component Location Index
- Brake System Inspection and Test
- Symptom Troubleshooting
- Brake Pedal and Brake Pedal Position Switch Adjustment
- Parking Brake Inspection and Adjustment
- Brake System Bleeding
- Brake System Indicator Circuit Diagram
- Parking Brake Switch Test
- Brake Fluid Level Switch Test
- Front Brake Pad Inspection and Replacement
- Front Brake Disc Inspection
- Front Brake Disc Replacement
- Front Brake Caliper Overhaul
- Master Cylinder Replacement
- Master Cylinder Inspection
- Brake Booster Test
- Brake Booster Replacement
- Rear Brake Pad Inspection and Replacement
- Rear Brake Disc Inspection
- Rear Brake Disc Replacement
- Rear Brake Caliper Overhaul
- Brake Pedal Replacement
- Brake Hose and Line Inspection
- Brake Hose Replacement
- Parking Brake Cable Replacement
Brakes
...
Special Tools
...
See also:
General Troubleshooting
Information
Mow to Check for DTCs with the HDS
NOTE: Check the vehicle battery condition first {see page 22-90).
1. Make sure the ignition switch is turned to LOCK (0).
2. Connect the HDS to the data link ...
Drive Plate Removal and Installation
1. Remove the transmission assembly (see page
14-194).
2. Remove the drive plate (A) and the washer (B) from
the engine.
3. Install the drive plate and the washer on the engine,
and tighten t ...
Housing and Shaft Assembly Removal
Special Tools Required
Housing Puller 07HAC-PK40102
1. Remove the ATF feed pipe (A) from the idler gear shaft, and remove the ATF
lubrication pipe (B) from the
transmission housing.
2. Remove ...