Instrument Panel

Features

See also:

Mainshaft Inspection
1. Inspect the gear and bearing contact areas for wear and damage, then measure the mainshaft at points A, B, C, D, and E. If any part of the mainshaft is less than the service limit, replace it. ...

Shift Lock Solenoid Test
1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard. 2. Turn the ignition switch to ON (II). Make sure the HDS communicates with the PCM. If it does not, go to the ...

Connecting Rod Bolt Inspection
1. Measure the diameter of each connecting rod bolt at point A and point B. 2. Calculate the difference in diameter between point A and point B. Point A-”Point B = Difference in Diameter D ...