Honda Accord: Control Unit Input Test/Replacement
1. Remove the driver's dashboard lower cover (see page 20-166).
2. Remove the screws, then disconnect the 28P connector (A) from the HandsFreeLink control unit (B).
3. Inspect the connector and socket terminals for a good pinfit to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, go to step 4.
4. Reconnect the connector, and make these input tests at the connector.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, go to step 5.
5. Disconnect the 28P connector again, and make this input test at the connector.
• If the test indicates a problem, find and correct the cause, then recheck the system.
• If the input test proves OK, the HandsFreeLink control unitis faulty, replace it.
HFL Switch Removal/Installation
1. Remove the steering wheel (see page 17-6). 2. Remove the HFL switch (see page 17-7). 3. Install the HFL switch in the reverse order of removal. ...Restraints
Special Tools ...See also:
Rear Inner Fender Replacement
NOTE: Take care not to scratch the rear bumper or the
body.
1. Remove the screws, then remove the rear inner
fender (A) from the rear bumper (B) and the body.
2. Install the inner fender in th ...
Synchronized Mode
You can set the temperature synchronously for the driver side and the
passenger
side in synchronized mode.
1. Press the SYNC button.
- The system will switch to the synchronized mode.
...
Selector Control Shaft Oil Seal
Replacement
Special Tools Required
-Driver Handle, 15 x 135L 07749-0010000
-Oil Seal Driver Attachment 07947-ZV00100
1. Remove the oil seal (A) from the torque converter
housing (B).
2. Install a new oil s ...