Honda Accord: Connecting Rod Bolt Inspection - Engine Block - Engine Mechanical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Connecting Rod Bolt Inspection

1. Measure the diameter of each connecting rod bolt at point A and point B.

2. Calculate the difference in diameter between point A


2. Calculate the difference in diameter between point A and point B.

Point A-”Point B = Difference in Diameter

Difference in Diameter

Specification: 0-”0.1 mm (0-”0.004 in)

3. If the difference in diameter is out of specification, replace the connecting rod bolt.

    Piston Installation
    If the Crankshaft is Already Installed 1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. 2. Remove the connecting rod caps, then install the ring co ...

    Crankshaft Installation
    Special Tools Required Driver Handle, 15 x 135L 07749-0010000 Attachment, 24 x 26 mm 07746-0010700 Oil Seal Driver Attachment, 96 mm 07ZAD-PNAA100 1. M/T model: Install the crankshaft end bushing ...

    See also:

    Compact Spare Tire
    Use the compact spare tire as a temporary replacement only. Get your regular tire repaired or replaced, and put it back on your vehicle as soon as you can. Check the air pressure of the com ...

    Rear Door Sash Outer Trim Replacement
    4-door NOTE: Take care not to scratch the door. 1. Remove the door outer molding (see page 20-54). 2. Pull up the door sash outer trim (A) to release the trim from the clips, and release the t ...

    Oil Jet Replacement
    1. Remove the oil pump (see page 8-17). 2. Remove the baffle plate (see step 8 on page 7-14). 3. Remove the oil jet bolts (A), then remove the oil jets (B). 4. Carefully install the oil jets ...