Special Tools

* : Part of Mainshaft Inspection Tool Set, 07GAJ-PG20102. * * : Must be used with commercially available 3/8"-16 UNF Slide Hammer. * ...

Symptom Troubleshooting Index

...

See also:

Mainshaft Disassembly, Inspection, and Reassembly
1. Inspect the thrust needle bearings and the needle bearings for galling and rough movement 2. Inspect the splines for excessive wear and damage. 3. Check the shaft bearing surface for scorin ...

System Check
1. Connect the HDS to the data link connector. 2. Turn the ignition switch to ON (II). 3. Monitor the SYSTEM CHECK in the IMMOBILIZER INFO with the HDS. 4. If the HDS displays NORMAL N-1,the ...

Hood insulator Replacement
For Some Models NOTE; Take care not to scratch the hood. 1. Detach the clips with a clip remover. Remove the hood insulator (A) by pulling it away from the hooks  (B). 2. Install the ins ...