Fuel Supply System

...

DTC Troubleshooting

DTC P0461: Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Range/Performance Problem NOTE: - Before you troubleshoot record all freeze data and any on-board snapshot, and review the general ...

See also:

Piston Installation
If the Crankshaft is Already Installed 1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. 2. Remove the connecting rod caps, then install the ring co ...

Fog Light Bulbs*
When replacing, use the following bulbs. 1. Loosen the screw using a Phillips-head screwdriver.  - Be careful not to rotate the screwdriver more than one or two times to the left. ...

Transmission End Cover
End Cover Installation Exploded View Special Tools Required Mainshaft Holder 07GAB-PF50101 NOTE: Refer to the Exploded View as needed during the following procedure. 1. Install the mainshaft ...